LED Lighting fixture installation

Submit Audition/Proposal on this Project
Rate this Project

Project Main Details

LED Lighting fixture installation 
ZD1447187
Looking for a clear, bright male voice to run thru the step by step instructions to install a retrofit lighting kit. Will need a smooth delivery with pauses between lines. The video will be used on line to support product and installers looking to change out fixtures. 
2016-10-18 22:27:23 GMT
2016-10-21 17:00:00 (GMT -06:00) Central Time (US & Canada) 
Yes (click here to learn more about Voice123's SmartCast)
Closed
18
18
0 direct invitation(s) have been sent by the voice seeker resulting in 0 audition(s) and/or proposal(s) so far.
Voice123 SmartCast is seeking 30 auditions and/or proposals for this project (approx.) Invitations sent by SmartCast have resulted in 18 audition(s) and/or proposal(s) so far.

Project Parameters

The Voice Actor should be located in:
Fixed - USD 100
Training, business presentations, sales, and web sites
No
1 PAGES
English - USA and Canada
Not defined
Middle Age Male
• Audio files must be delivered via FTP/Dropbox/Google Drive/cloud
There are no special pre-, post-, or production requirements for this project.
Not defined
The voice seeker is willing to hire either union or non-union talents for this project

Script Details

Yes
N/A 
In this installation we will be converting a fluorescent fixture with the JCLR6 LED Retrofit Kit.

We’ll begin by turning off the power to the fixture at the circuit breaker box.
Remove lamp and existing trim section from housing to gain access to rough in section of junction box.
The socket assembly can remain attached or removed as desired.
Remove junction box access cover.
Disconnect all primary input wires.
Note that the Retrofit conduit whip assembly is provided with quick disconnect connector located in LED driver junction box.
Connector can be disconnected to separate reflector from supply wire connection.
This allows for easy installation of supply wire connection to retrofit without reflector interference.
Remove knockout and insert the 1/2 inch fitting.
In this installation the purple and gray wires will not be used. They are intended for use with 0-10 volt dimming.
Connect supply wires to the retrofit trim wires. 
Please note that you should only use the script or your recording of it for auditioning purposes. The script is property, unless otherwise specified, of the voice seeker and it is protected by international copyright laws.

Voice-Seeker Details

97065
Sign in to display the company name (if applicable)
2014-06-30
9

12


Voice123 Team Comments

Voice123 consultations with this voice seeker regarding this project and/or other projects by this voice seeker, via phone, chat, and/or email.


unchecked This project - phone.

unchecked Previous projects - phone.


unchecked This project - email or chat.

checked Previous projects - email or chat.



Note: Voice123 strives to establish the legitimacy of all projects posted. However, Voice123 subscribers and users are responsible for confirming information stated by prospective voice seekers, agents and/or clients. Voice123 subscribers and users assume all liability for use of any information found through Voice123, or any of its publications.

This page contains the most important details of this project. If you find the information on this project inaccurate or inappropriate, please let us know by contacting us.

Submit Audition/Proposal on this Project